I'm using the coil guard with the official E-Elev8r. It took a lot of tweaking to get it just right and I ended up striping one of the screws. I had to install Elev8r quartz heater upside down or the opposite direction I had prior to the coil guard. I have the Elev8r quartz heater nipple pinched at the base of the coil locking the coil and guard in place on the quartz heater so there is little movement. The coil guard does not cover the bottom of the coil which is fine it gives the quartz heater enough length to not touch the Elev8r WPA and if the coil fell it would be different for the coil to touch anything. I have the PID set at 485° and take long slow draws. While idling I can pick up the heater by the coil guard and it's not too hot to hold. Immediately after drawing it's a little to hot to handle the same way. I don't have any balls installed in the quarts heater but the guard does retain some radiant heat I think which is why I can run the temp so low. I'd say the coil guard is not necessary if you are extremely cautious but well worth the money and time installing in the rare instance I knock over my rig. When looking for a guard after getting the E-Elev8r VGoodiEZ had the tallest guard and the best price. I can't leave anything stock and I am very happy with the guard/setup. Thanks VGoodiEZ.

It fits okay on my b-zero, havent had any issues!

Does this fit on the cloud connoisseur armored omega? (Couldn’t figure out how to leave a question rather than a review.)

Able to bend to fit around desired Enail, only gets warm, definitely worth it, would even prevent a possible 🔥 nevermind burning your face or hand